Recent content by TechTy

Thank you for the excellent explanations! It is very helpful.

I finally got it to work again. I ended up changing the VLAN 2 tag to VLAN 4 to start over with my coniguration. I didn't setup the PVE to use the VLAN in the network config since I don't want my PVE to have an IP on VLAN 4. I set the switch VLAN 4 config to tag port 1 (connected to the...

I tried some troubleshooting with changing the tagged status of VLANs on my switch and rebooted the PVE server after most of the changes to try and find the correct configuration but I don't really know that much about how VLANs are supposed to be configured for tagging on the switch side (I...

Interface: # network interface settings; autogenerated # Please do NOT modify this file directly, unless you know what # you're doing. # # If you want to manage parts of the network configuration manually, # please utilize the 'source' or 'source-directory' directives to do # so. # PVE will...

help?

I have a VLAN (VLAN2) that I recently setup to separate all my hosts that are accessible from outside my network from the internal hosts. Everything was working fine until I made two changes (not sure which one broke the VLAN). The first change was upgrading my PVE-7.0-2 (or something close to...

Yeah that’s what I was doing but something was wrong with the hard drive I was using I think

I got past the problem. I forget exactly what I did but it was either by using a different installation thumb drive or replacing the drive that I was installing to

My motherboard is an intel s5520hc, I have 2 Xeon e5640, I had 32GB of ram last time I installed proxmox successfully and then got 32GB more ram but if I remember correctly it’s a different speed and brand (which might be my problem now that I think about it but everything worked fine before), I...

While trying to install proxmox 7 as a fresh install the installer hangs at 99% “making system bootable” and doesn’t complete even after 9 hours. I tried it while watching the TTY (ctrl+alt+f2) and it says “Installing for x86_64-efi platform.” and doesn’t respond to any keystrokes (such as...