Since it works with pfSense, your Proxmox VLAN-aware bridge and trunk configuration are most likely correct.
On OPNsense, I’ve seen cases where traffic reaches the interface (visible in tcpdump), but you still get no reply, even with an “allow...
Hi,
yes, i have different DHCP pools for vlan10/20/30.
I've installed pfsense instead of opnsense and everything seem to be working correctly.
Maybe it was an issue on opnsense configuration side.
Hi all,
I want to use a nic in vlan aware mode to connect multiple phisical devices.
Below is my networking diagram.
vmbr0 and vmbr1 are working fine, i'm not able to configure vmbr2 (LAN in vlan aware mode).
This is my network interface:
auto...