Recent content by spinner

Thanks for your reply. I actually got this to work on another setup I tried. What seems to cause me the most problems is that I have 4 NICs that I would like to setup with 2 bonds. Apparently thats not supported out of the box, and I haven't successfully been able to configure 2 bonds without...

Hi. Continuing to explore Proxmox I'm trying to setup the networks as I'd like it. I have two boxes with 4 NICs each. A Supermicro X10SDV-6C and a Supermicro A1SAi-2550. Two of the NICs on each machine are wired to a switch. The other two are wired directly between the two machines. Now...

Hi. Still very new to Proxmox I'm trying to get the network setup correctly before getting into the storage part. I have a simple LACP (linux) bonding setup on two NICs (bond0), and then added two Linux Bridges on top of that bond. The bridge that operates on the untagged works just fine...

I think I solved this. I reinstalled Proxmox to verify that the problem wasn't caused by something gone wrong during the installation. The problem was the same afterwards, but I did notice that I could actually select one of the to 10gbe nics as my management nic during installation. They were...

Here you go.

So, looking a bit further into this, I think maybe the device drivers are loaded properly, as >lspci -s 03: -nnvvv actually ends with Kernel driver in use: ixgbe Kernel modules: ixgbe...

Thanks both for your reply. I've checked with modinfo ixgbe that the driver is actually present: filename: /lib/modules/4.10.15-1-pve/kernel/drivers/net/ethernet/intel/ixgbe/ixgbe.ko version: 5.0.4 proxmox-ve: 5.0-15 (running kernel: 4.10.15-1-pve)...

Hi all. New to this forum and Proxmox, so please bear with me :) I just installed Proxmox VE 5 on a Supermicro X10SDV-6C-TLN4F board. The 1 gbit NICs where recognized right away but not the 10 gbit ones. I've been looking a little bit around and from what I've been able to tell, I need to...