sightkick's latest activity
-
Ssightkick replied to the thread Proxmox won't complete the reboot.Maybe thats the cause why DELL won´t official support Proxmox :-(
-
Ssightkick replied to the thread Encountered a issue reboot when upgrading pve version 8 to 9..The solution for me is found! It wasn´t the controller. The problem ist the Kerner >6.5 with the Broadcom network interface cards. The are not compatible. If you disable them in system Bios the machine ist booting fine (PVE9) without any error...
-
Ssightkick replied to the thread Proxmox won't complete the reboot.The solution for me is found! It wasn´t the controller. The problem ist the Kerner >6.5 with the Broadcom network interface cards. The are not compatible. If you disable them in system Bios the machine ist booting fine without any error AND with...
-
Ssightkick replied to the thread Proxmox won't complete the reboot.Today I did a clean install on a SSD SATA Disc without controller AND the problem appeared again. In the r/Proxmox forum I´ve found some people with the same problem...
-
Ssightkick reacted to pbee's post in the thread Broadcom Tigon3 "tg3" ethernet driver in Proxmox kernel is buggy or old with
Like.
Indeed... why is this not fixed yet? Multiple threads about TG3 issues exist already on this forum. I'm getting tired of either crashing TG3 drivers or unresponsive broadcom network interfaces. Or is there a better driver available that can... -
Ssightkick reacted to DavidGA's post in the thread Broadcom Tigon3 "tg3" ethernet driver in Proxmox kernel is buggy or old with Like.
The tg3 driver included in the Proxmox VE kernel for Broadcom Tigon3 ethernet occasionally crashes out with: DMA Status error. Resetting chip. Usually the interface comes back after a few seconds. Sometimes it doesn't, and the system must be...
-
Ssightkick replied to the thread Proxmox won't complete the reboot.Same for me. T440 with PercH730P. Checked older Controller Firmware but nothing worked. It shuts down until the cache of my disks is synced back and then comes "No signal". A Warm power cycle helped as a one-shot-workaround. Same as OP. Error...
-
Ssightkick replied to the thread Encountered a issue reboot when upgrading pve version 8 to 9..I have the same issue. Exchanged with a second "same" controller for troubleshooting purpose. Changes to HBA Mode with only one harddrive. Proxmox 9 fresh installed. But no success. From the first reboot on the error occurs. I think the error...