Hello,
Thank you very much for this quick reply.
I just added the pvetest repo and updated the corresponding packages, however, as it seems, this does only fix the password issue (second command) to some extend, but not the other issue (first command):
pvesh create...
Hello,
I have an issue with the commands for setting up VNC access via IP & Port with password authentication using PVESH or the "Monitor" section in the Web-GUI.
Within Proxmox 6, it was possible to configure VNC access using the following commands:
pvesh create...
Seems like the issue got fixed as I could successfully update everything now without any warning.
However, please find attached the requested information.
Hello,
I just tried to upgrade the Proxmox VE environment as apticron listed the following available updates:
libcephfs2 14.2.16-pve1
liblttng-ust0 2.10.3-1
liblttng-ust-ctl4 2.10.3-1
libnvpair3linux 2.0.3-pve2
liboath0 2.6.1-1.3
librabbitmq4 0.9.0-0.2
librados2...
There is a workaround for this:
1) Create the QWORD-Key "RealTimeIsUniversal" within Windows at HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\TimeZoneInformation and set the value to "1".
2) Execute the following command on the Proxmox Host: "qm set --localtime 0 <VMID>"
3) Reboot the VM...
Auf welche der Fehlermeldungen beziehst du dich denn? Die meisten davon können ignoriert werden, da die keinerlei Auswirkungen auf die tatsächliche Funktionalität haben.
Wie sieht denn jetzt die Ausgabe von ifconfig aus?
Eigentlich brauchst du der WLAN-Karte keine eigene IP geben, da Proxmox selbst ja die Bridge benutzt. Also ginge auch folgende Konfiguration:
auto lo
iface lo inet loopback
iface eno1 inet manual
auto vmbr0
iface vmbr0 inet dhcp
bridge-ports wlp0s20f3
bridge-stp off
bridge-fd 0
auto...
Das sollte die WLAN-Karte sein, die nun noch in der "/etc/network/interfaces" konfiguriert werden muss (sollte dann Methode 1 sein). Dann sollte man auch eine Verbindung mit dem WLAN-Netz aufbauen können: ifup wlp0s20f3
Damit am Ende auch alles über die WLAN-Karte läuft, müsste dann noch eine...
Just successfully performed the upgrade from the latest 5.4 version to 6.0.
The only thing that came to my attention during the installation was that grub did not recognize the grub installed on my two S-ATA SSDs, which are running in a zpool mirror and contain the Proxmox installation. After...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.