Recent content by pherrera_tamu

Fiona, Thanks for the reply. The logs above included the output of journalctl for the services. However, I'm happy to say that we likely found our issue and solution. It appears that a recent upgrade to the iDRAC9 f/w from v6 to v7 series was the culprit. After reverting to v6 and rebooting...

Running PVE 8.0.4 ipmi_watchdog configured After disabling maintenance mode via ha-manager crm-command node-maintenance disable node3, ha-manager status shows: lrm node3 (old timestamp - dead?, [date & time]) ... service vm:XXXX (node3, freeze) systemctl status watchdog-mux pve-ha-lrm shows...

That was it. We did not have HA active with at least one VM running under HA. Thanks!

Sorry got sidetracked with other projects... Yes, that does help. However, we didn't witness the behavior we expected. With cluster network traffic down, the two "up" nodes and the "down" node could not communicate. But the "down" node did not get fenced. We now understand why this is the...

We are testing a new cluster (VE 8.0.3). We believe we've enabled watchdog in the bios. Without going over to the data center and pulling cables, is there a way to test fencing a node? Thanks!

We recently purchased three small servers and need advice on the network setup. What would be recommended with regard to distributing the network services amongst the adapter/ports? Both adapters are npar capable. 3x Dell 6515 with: 1x AMD 7542 128 GB memory 2x 1Gb nic 2x 25GbE sfp28 (Broadcom...

I've also followed the directions on http://pve.proxmox.com/wiki/HTTPSCertificateConfiguration. I did restart the two services. I'm also getting the same "Error: TLS .... certificate does not match" error. Please advise. Thanks.

I have tried googling and searching the forum with little success. What is the template used for after a container is created? For example, can I delete the template of a running container? Thanks