Recent content by Nick_W

  1. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    Finally, still not sure why I wasn't able to get the onboard ones working, but setting it up with the enS ones did the trick, thanks!
  2. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    Oh, so the ensX ones are the ones I need to configure, thanks!
  3. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    I had removed the flexibleLOM one, as it was just cluttering up the network output, I have added it back in, not much changed.
  4. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    The onboard NICs are some sort of PCI based connector, the call it a FlexibleLOM, it has 4 GBE interfaces. Something like this Here are those files..
  5. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    Anything odd in those files? So, I installed 6.2, and got basically back to the same situation. One thing I've noticed is that the devices (card and bridge) were in LOWER UP, vmbr0 is in state UP, but enp1s0f4u4 is state UNKNOWN, I've seen some people saying it was an issue with PCIe ports, so...
  6. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    Alright, here's lspic -nnk and the journal files, probably going to try a 6.2 install, just to see if it is the hardware..
  7. N

    [SOLVED] Problems with networking on an HP DL360 G10 and Proxmox 6.3.1

    I've got a brand new DL360 G10, 2 x Xeon G 5218, plenty of ram, and installed the latest Proxmox 6.3.1 on it without issue. No errors or hiccups during install. Networking however has been a problem since the start. The machine had a 4 port Gigabit ethernet card on board, which connected (picked...
See more
Top Bottom
Back