Recent content by netbone

Now decided to replace Proxmox with Openvz panel - now all works finde.

anybody who can help with that case?

Now I have added an eth0 in webgui, but it is not visible inside the container by trying with ifconfig. I have also tried to add manually in network/interfaces an eth0 entry - still not visible. and remember venet0:0 is not reachable, venet0:1 is pingable ... did not understand this. But the...

everything correct inside container, too:

No. Have not tried. With Proxmox 1.x this was not necessary. Additonal - why it is possible to reach always one of the IP addresses I gave the container, but not all IPs (even when they are from the same network)? The iptables rule is already removed - that was a test, but without ip tables...

Nobody any idea? Any assistance would be helpful?

But still can't reach container from outside.

Solved by using: iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE

the arp requested is received by the host: But the host did not answer. And the host itself can ping the container: venet0 is up The container can't ping anything outside: IPs inside container are correct: IP address which is configurated as venet0:0 can be reached from outside, but...

I really become silly now. I first had a 2.x cluster with 3 nodes. 1 node crashed and it was not possible to remove the crashed node from the cluster. I tried to setup the node completly new and first it was possible to add the node again to the cluster. Then the IP addresses and hostnames...

hell - now vzlist is empty. but all containers are still here: drwxr-xr-x 20 root root 4096 May 6 00:05 100 drwxr-xr-x 20 root root 4096 May 6 09:21 101 drwxr-xr-x 21 root root 4096 May 10 16:15 102 how to start or reacitvate the containers now?

yep. this is what i did - and as result i have two clusters, but i want a cluster and a node. Additional - running (!) - containers disappeared from webgui on kemp010 Additional in ssh all additional ip addresses disappeared when I take a look with ipconfig, but containers with not listed IPs...

And how to transform a cluster into a node? Can't find anything about it on manual or wiki or forum.

pvecm status Version: 6.2.0 Config Version: 1 Cluster Name: kemp010 Cluster Id: 2970 Cluster Member: Yes Cluster Generation: 4 Membership state: Cluster-Member Nodes: 1 Expected votes: 1 Total votes: 1 Node votes: 1 Quorum: 1 Active subsystems: 5 Flags: Ports Bound: 0 Node name: ks010 Node ID...