Recent content by miqu

@fireon, I'd like to kindly ask whether there will be support for Proxmox 8? Thank you.

Same for me as I am also using LVM and nginx inside a docker container. I haven't continued my investigation, but I will need to move the container as I am running out of disk space. Have you had any success yet?

@bennetgallein, my issue seems to be exactly the same as yours. I have an LXC with Docker and in it quite a few containers that are running nginx (nextcloud, swag proxy, heimdall, ...). Now I'd like to move the disk of the container to a different drive, however, the rsync command (initiated...

Grundsätzlich stimmt das. Aber wie so häufig steckt der Teufel im Detail. In meinem Fall sind das bspw. Passthrough der iGPU benötigt z.B. Anpassungen bei den Modulen und im Grub. Um Bluetooth zu aktivieren und auch durchzuschleusen sind aktuelle Firmware Files notwendig, die in den richtigen...

Hallo, wie seid ihr mit euren Plänen hier vorangekommen? Die Idee mit Clonezilla finde ich persönlich auch am besten, um gelegentlich ein komplettes Backup des Hosts zu erstellen auf das man z.B. nach einem fehlgeschlagenen Update zurückgreifen kann. Clonezilla nutze ich schon seit Jahren für...

The downgrade via apt install lxc-pve:amd64=4.0.3-1 solved the issue for me on two lxc containers. The one was running docker and the other was the openvpn turnkey container which was also affected. Thanks!

I think I found a possible reason and it is due to the fact that I am passing through 2 devices to the guest VM: the IGPU and the bluetooth module. The latter one (00:14:3) shares the same prefix of the address as the USB controller (00:14:0). As a consequence all USB devices are no longer...

Thanks for your reply. The filesystem is ext4.

The drivers were the ones that came with the Windows10 image I was using (Win10_20H2_v2_EnglishInternational_x64) and created according to the general HowTo. Maybe this image is newer than the one you were using and comes with the more recent drivers that get used automatically. I will try again...

Hello, thanks for this very useful tool. I have attached a 1.5TB HDD via USB3. It gets recognized and I find it in /media/sdb1/ and create backups from my two lxc containers. However, I cannot create a backup of my VM on this external drive. It is possible to copy, also big files, to...

So, I can get rid of the Code 43 error by removing addr=0x18 from the conf file. After that I can boot successfully, however, still not get any output from the HDMI. I tried this now also several times and can reproduce it reliably. With this setup, I need to note, I am able to access the VM via...

Thanks again for your reply. I adjusted my config in the same way as you suggested: - Edited the two lines in the grub config according to your example - Removed the vfio.conf - Applied update-grub and update-initramfs - Adjusted the vm conf file (with the addr) - Rebooted - Started the Windows...

Thanks for your reply. That change alone still results in Code 43. So I suspect something else in my config differs from yours. Here's my current vm config: I have the same since yesterday already and noticed no difference Looking forward to compare with your settings.

@Adrianos712, I got the very similar NUC 8I5BEK with Intel Iris 655 and I tried all possible ways to pass through the IGPU to a Windows 10 guest but couldn't make it work yet. I tried with OVMF and SeaBios but end up with the graphics card being recognized by the Windows guest system, however...