Separate names with a comma.
My Proxmox host is the GW for my VM's indeed. It's a port routed subnet for the host, so that is why.
Sure sorry for the delay but can you post yours ? I would like to test upfront, I might see some flaw.
No problem, me as well! Let's teamup again :)
Any update on this from your side spirit ?
It's a little bit hard to answer, it worked before and ipv6 forwarding is enabled:
# cat /proc/sys/net/ipv6/conf/all/forwarding
From a VM...
IPv4 works, IPv6 doesn't. Sorry for the missing detail!
IPv6 has eth0 on forward, the vmbr11 and the rest is 0.
OK I'm testing this out and it's strange.
I can stil ping my Proxmox bridge but nothing to the outside world. On my Proxmox box itself I can...
Sorry for the delay, I will report back asap :) Thanks again!
Great, going to try it in a few hours! Is the bond change applied as well (yet) ?
I already thought, good work! It's nice to work with a reference and see if changes just should be made and Cumulus is also just seeing if there...
Another update on this.
IPv6 doesn't seem to forward at all, only one bridge is in :1 mode, vmbr11 and none of the interfaces is with ip-forward...
You were very welcome, great!
To be precise; We need the "workaround" or the package will be updated in some time and will float into Proxmox ?...
That works indeed!
I must say I only need to do it on the ethX interface that has an address. I have 2 interfaces in a bond and they can live...
New update, this makes it work again:
echo '1' => /proc/sys/net/ipv4/conf/eth<X>/forwarding
It's the same config as in my startpost.
I see that ethX are forwarding:0 after the reload which are forwarding:1 before. The bridges, except...