Recent content by KarlB

I will look into ZFS on other servers, but I'm not using it currently on the server in question. I have LVM set up running EXT4, so I suppose I could use LVM for the backup, but I expect that I'm going to have to set this up manually.

I am currently running Proxmox 4.4 with various containers. I have a weekly backup set up, which takes quite a while to run to an off-site NFS share. I'm using the 'snapshot' mode, which the documentation says offers the lowest operation downtime. I notice that this mode makes a container...

I can try that when the error occurs again, but I was able to connect to port 80/443 on 192.168.1.42 from other servers/workstations (on the same interface) without any problems.

I'm running Proxmox 4.3-1/e7cdc165. I have a host, 'Marvin', running Proxmox and several containers. Since this is in our office, as a development environment, we have a single external IP address. I use Apache on Marvin to proxy specific sites to specific containers. The issue is that...

Thank you. In this case, the data is separate from the installation, but there is configuration of the system itself. I have been using Ansible, so it seems like it would be easier to reinstall, automatically configure as much as possible and change a few bits by hand.

I have some KVM virtual machines running outside of Proxmox. Is it possible to convert or transfer those virtual machines into Proxmox to run as a container? Or is it simply easier to re-install as a new container? There's a lot of information available about converting to KVM, but not much...