Recent content by jjakob

No differences in the installer, weird. I guess it's possible I selected the 2nd port in the installer, but would the installer let me continue with the cable not plugged into it?

I've rebooted 3 times now and the interface naming stayed the same. So I'm pretty sure they must've been switched in the installer. If it were a PCI bus or slot change, the pX or sX would have changed but they didn't, just the fX changed, which in systemd naming means "function". Per this post...

No, I just unplugged the USB drive that had the installation ISO and let it reboot into PVE.

Thank you for your suggestion. I'll try rebooting a few times to see if the naming stays the same or if it switches. I knew about udev, but I think this is managed by systemd now? But I think the names now should be stable, as the 'enp2s0f0' is the interface with the lower MAC (first port), and...

A fresh installation of PVE 6.2 from the official ISO, during the installation, the ethernet cable was plugged into the first ethernet port. The network was detected, configured and the installation finished successfully. After rebooting into the installed system, there is no network...