Recent content by jimz0r

Thanks to you we were able to solve this issue. I had to add all nodes again (fence_tool join) Now rgmanager is running again. One last question. When 3 nodes are running all with vm's in HA. Does RGManager need to be running on all nodes or only on one node?

Hello Tom, Thank you very much for you reply's. I used the command but same results as my post above when using the other command. root@Proxmox01:~# service cman start Starting cluster: Checking if cluster has been disabled at boot... [ OK ] Checking Network Manager... [ OK ]...

Hello Dietmar, Today we had our first test day with 25 users working on 38 vm's and beyond that we are using old hardware our test passed. 3x HP proliant Proxmox 3.1 1x HP proliant Freenas 2x MSA 60 storages 24x 500gb 7.2k hd configured as raid 5 Now i can focus back on HA because its a...

So nobody has any idea about this RGManager issue?

Thank you for your reply. We found out that the kvm option was not enabled in the bios settings of one of the servers. However we have tested by disconnecting a utp cable from Proxmox02 and it worked, for a while.. After the test we rebooted Proxmox02 and now we are with the same problem...

Thank you very much Dietmar that solved the issue, but.... I'm trying to test the HA by starting 2 VM's (They are managed by HA). But they won't start, after 10 minutes the output is still : Executing HA start for VM 100 Member Proxmox01 trying to enable pvevm:100... Our goal is to get a...

root@Proxmox01:~# dlm_tool dump 1385541785 logging mode 3 syslog f 160 p 6 logfile p 6 /var/log/cluster/dlm_cont rold.log 1385541785 dlm_controld 1364188437 started 1385541785 logging mode 3 syslog f...

Thank you for your reply. but there is no rgmanager.log located in /var/log/ Best Regards, Jimmy

Hi, i'm trying to set up a test cluster with 3 nodes in HA with a fencing device. when i'm trying to active it at the HA tab i'm getting the follow error: When i go to Node > services > start RGManager it says: Starting Cluster Service Manager: [ OK ] TASK OK But the status says ''stopped''...

Hi, Still the same problem. Everything is configured properly now. - 3 Proxmox ve 3.1 Nodes - Nodes are in cluster. - Shared storage by NFS Configured as HA ( followed instruction from the Fencing wiki page) http://pve.proxmox.com/wiki/Fencing#Enable_fencing_on_all_nodes Failover...

Thank you for your reply. I have forgotten that it needed 3 nodes, I have installed a third node. I'm now started with the configurations. I will update the status when everything is configured. Thanks, Jimmy

Seriously, does nobody have any ideas? Even the admins. So i have payed €49,99 for this terrible support forum for really bad support. This is really outrageous.

It's fixed it was something in the script. now we have a new problem. When i go to Node > services > start RGManager it says: Starting Cluster Service Manager: [ OK ] TASK OK But the status says ''stopped'' When using /etc/init.d/rgmanager start in CLi it says the same...

dietmar, tom do you have any idea? we have tried everything.

I have tried all those options but nothing changes. Maybe you can try to install w8 yourself so you can see the issue.