Recent content by jesusjimenez

Last night I've successfully upgraded Proxmox 4.4 to 5.1 with CEPH upgrade following these guides: https://pve.proxmox.com/wiki/Ceph_Jewel_to_Luminous https://pve.proxmox.com/wiki/Upgrade_from_4.x_to_5.0 I've encountered two problems during CEPH upgrade: 1) "pveceph createmgr" - my previous...

with CEPH?

Hi everyone, I would like to change IP addresses used for CEPH communication on my 3 node Proxmox cluster. Have you done anything like this before? Is it enough to change monitor addresses and public network range in /etc/ceph/ceph.conf and monhost in /etc/pve/storage.cfg? Thanks for any answer

worked for me too

I confirm it is caused by Privacy Badger... And no, it is not new as I have 4.3 installed and PB was installed maybe two days ago. So maybe is it some new version of PB?

So I tried apt-get update && upgrade on one of my servers, so it looks like this: proxmox-ve: 4.1-37 (running kernel: 4.2.8-1-pve) pve-manager: 4.1-13 (running version: 4.1-13/cfb599fb) pve-kernel-4.2.6-1-pve: 4.2.6-36 pve-kernel-4.2.8-1-pve: 4.2.8-37 pve-kernel-4.2.0-1-pve: 4.2.0-13...

This is the current kernel. I can't give you output of the previous one... root@sm01:~# modinfo igb filename: /lib/modules/4.2.6-1-pve/kernel/drivers/net/ethernet/intel/igb/igb.ko version: 5.2.18-k license: GPL description: Intel(R) Gigabit Ethernet Network Driver author: Intel...

No Realtek, only Intel 04:00.0 Ethernet controller: Intel Corporation Ethernet Controller 10-Gigabit X540-AT2 (rev 01) Subsystem: Super Micro Computer Inc Device 1528 Kernel driver in use: ixgbe 04:00.1 Ethernet controller: Intel Corporation Ethernet Controller 10-Gigabit X540-AT2 (rev 01)...

Looks like network drops stopped since two weeks ago - I'm not sure which update caused this, but HELL I don't care. I did any config nor hardware change, only apt-get upgrade.

Sure. Dedicated hardware. No drops between CEPH nodes on dedicated NICs, no drops between Proxmox management network on dedicated NICs, no drops on LXC hosts, no KVM drops on private VLAN network on bridge vmbr0 and finally huge KVM network drops on public VLAN network on bridge vmbr0. Proxmox...

I've got three, each per 5.500€ My boss is going nuts :)

Network still freezing, I have to move my VMs to the dedicated servers as my clients are really pissed off.

Welcome to the club https://forum.proxmox.com/threads/network-drops-on-new-vms-not-old.25069/#post-125743

Thx, works ok.

I'm facing this issue too. Looks like it comes only on KVM guests, LXC guests are OK. My setup is vmbr0 on eth1 connected to the switch trunk port. On this bridge I set up eth0 and eth1 for KVM guest on VLAN10 and VLAN20. eth0 on VLAN10 has public IP eth0 on VLAN20 has private IP When it comes...