Recent content by forsytheda

Do I use this in conjunction with setting a gateway in the SDN vnet? Will VMs will use the vnet gateway as their gateway and then that gateway will forward to my announced type-5 route destination, or do I need to give the vyos node an IP address on the VXLAN directly to act as a gateway? My...

Hi spirit. I'm back again seeking some guidance on how I can configure external exit nodes. Here's my configuration thus far. Hosts pve01-05 eth0 192.168.20.11-15 vyos01-02 eth0 192.168.20.21-22 SDN I've setup an EVPN controller "evpn001" with the following settings: ASN #: 65001 Peers...

Here's some extra info just in case it helps. Physical network layout: ISP GW (192.168.10.1) <--> (192.168.10.50) Router Router (192.168.20.1) <--> Switch Switch <--> (192.168.20.10) Node 1 Switch <--> (192.168.20.11) Node 2 Switch <--> (192.168.20.12) Node 3 Node 2 [Exit Gateway]...

I'm back! After having to perform disaster recovery on my lab I have gotten things back up and running. Right now, I have 3 Proxmox nodes in a cluster running a evpn zone. There are two vnets each with their own vnet. Each vnet has a single subnet which has its own gateway. I can ping from a...

Neither of those seemed to work in getting my vm to connected to anything outside of the zone. I am seeing the networks from my router in the route table on pve02, and I see the networks for pve02 in the router, but they are unable to connect. I also am unable to ping the vnet gateway from the...

Thanks spirit. Here are my config files. zones.cfg --------- evpn: public controller c0 vrf-vxlan 10000 exitnodes pve02 ipam pve mac E6:F3:66:52:BB:51 mtu 8900 controllers.cfg ---------------- evpn: c0 asn 65000 peers...

So I'm doing some testing with this now. What I haven't been able to figure out is how i can configure my evpn zone to allow subnets to reach the internet. I tried to setup bgp between my proxmox cluster and my ha opnsense router so that opnsense could see and route between the sdn and the...