Recent content by foerkede

I'm sorry but I don't know what you mean by 'journal'? auto lo iface lo inet loopback iface eno1 inet manual iface eno2 inet manual auto bond0 iface bond0 inet manual bond-slaves eno1 eno2 bond-miimon 100 bond-mode 802.3ad bond-xmit-hash-policy layer2+3 auto vmbr0 iface...

Sorry for the late reply, but it still won't work. I tried to set it to 'auto', but then I get this from ifreload -a: "unsupported address method 'auto'". And when I set it to dhcp (as I want it), it doesn't seem to contact the dhcp server at all. I have a pfSense firewall running, but in the...

Hello, I am trying to get a IPv6 address for my proxmox host via dhcp, so I set up my /etc/network/interfaces like it is suggested in the debian docs: iface vmbr0.100 inet6 dhcp But that doesn't work, it doesn't set an address. Is there something I need to activate for this to work? When I set...

Yes that would probably work, I just hoped I could reuse the card for other vms and also use the internal switch. The software switch creates too much overhead, if i route gigabit through the vm the CPU gets to 100%. Just in case I get other hardware in the future: the VFs and PFs need to be in...

Ok that's disappointing, I already activated all possible things in the bios, even the SR-IOV options inside of the card's options in the bios. Sadly I can't use another PCIe slot, the rest are only x1. If there isn't another option to make this work (for instance not resetting the card...

root@pve2:~# lspci -nnk 00:00.0 Host bridge [0600]: Intel Corporation Skylake Host Bridge/DRAM Registers [8086:190f] (rev 07) Subsystem: ASRock Incorporation Xeon E3-1200 v5/E3-1500 v5/6th Gen Core Processor Host Bridge/DRAM Registers [1849:190f] Kernel driver in use: skl_uncore...

Sure. Just did an upgrage, problem stays. pveversion -v proxmox-ve: 6.1-2 (running kernel: 5.3.18-1-pve) pve-manager: 6.1-7 (running version: 6.1-7/13e58d5e) pve-kernel-5.3: 6.1-4 pve-kernel-helper: 6.1-4 pve-kernel-5.3.18-1-pve: 5.3.18-1 pve-kernel-5.3.10-1-pve: 5.3.10-1 ceph-fuse...

Hi, I'm trying to get the virtual functions of my Intel I350 passed through to a router vm. I got the SR-IOV working, basically following this guide on reddit. I also blacklisted their module so they don't get loaded by the host (tried both blacklist and adding to vfio-pci). Everything should...

I did switch back to linux bridges, but that wasn't the problem. Today I did some more testing and finally found my error: I already configured some VLANs on the switch and set "Accepted Frame Type" to "Tagged only" on the individual ports since the proxmox host should only send tagged frames...

I'm trying to set up LACP on my Proxmox using Openvswitch, but it's not working and I'm out of ideas and googling. I have a Zyxel GS1900, enabled LACP and created a LAG-Group with the 2 ports connected to my server. In Proxmox i set up the network like this: allow-vmbr0 bond0 iface bond0 inet...