Recent content by ewok2

Almost 3 weeks without any error, tahnks!!!

Thanks for help I have removed the scsiblock And configuer the disk with the doc "2" after rebuild of the raid it is Ok: Wait and see if it is stable :-)

Hello Jonas thanks for help No ZFS The OMV disk is in LVM-thin (on SSD NVMe Samsung 990 Pro 1To (local-lvm) The 2 IronWolf 4TB are connected in passthrough (scsiblock=1) throught ID ATA, (No passthrough of the full PCIe controler) With virtual controler virtio-scsi-pci In the VM (OMV/Debian)...

Hello I have install a proxmox server to replace an esxi server. => I am new to proxmox ;-) and it is much beter than esxi !!! On this server I have some VM Ubuntu, a pfsense VM and an OMV VM with 2 disk for the data in raid (mirror). But I get often error and the raid is KO. cat /proc/mdstat...

I have try to find some information on How to declare an AP on proxmox... but I dont see anything. is it possible through the WebGUI or is it like a debian in CLI ?

Thanks for Reply And with a routed configuration, is it possible to declare an Access Point with the card in Pfsense ?

lspci on the proxmox see the card : 03:00.0 Ethernet controller: Qualcomm Atheros AR242x / AR542x Wireless Network Adapter (PCI-Express) (rev 01)

Hello I have installed a proxmox + one pfsense VM on a HW with VT-x but no VT-d. The pfsense works fine with the 2 ethernet card. I have in the network conf 2 network device and 2 bridge (one device for one bridge) I have add a a PCIe Wifi card and I do not see it neither in proxmox gui neither...

Ok my fault There is a Option box near the selection of the disk to intall proxmox... where you can choose the parameter maxroot and swap :-) I was looking a way to enter in cmd line

Hi I would like to choose the size of the two disk "local" and "local-lvm" By default it is 30Gb and 80Gb and I dont need the local as big (more something like 8Gb) I have seen it was possible during install in proxmox 3.x but it seem's it does not work in 5.x Is there a way to choose the...