Recent content by eugene

Finally got it worked. I was able to drop current cluster config and recreate all things again. Starting working with cluster. :) The topic can be closed.

I am not sure, but I think the problem is that I added a node from main node (my mistake). But how to fix this? The sequence of executing of commands was almost like (don't remember exactly): 1) I copied ssh pub key from vmserv1 to vmserv 2) Created cluster: root@vmserv# pvecm create cluster...

Mmmmmm.... I found that I can't create or modify any VM's, getting "Node vmserv seems to be offline!". And I'm getting "cluster not ready - no quorum?" at tab "HA". Any thoughts?

Yes. The root FS mounted as usual and I have no problems with it. But /etc/pve is another mount location, which initiated by "pve-cluster", I think so. And as I can see "/var/lib/pve-cluster/config.db-wal" is the disk to mount to /etc/pve by "pve-cluster". "/var/lib/pve-cluster/config.db-wal"...

root@vmserv:~# pvecm status Version: 6.2.0 Config Version: 3 Cluster Name: cluster Cluster Id: 13364 Cluster Member: Yes Cluster Generation: 16 Membership state: Cluster-Member Nodes: 1 Expected votes: 1 Total votes: 1 Node votes: 1 Quorum: 1 Active subsystems: 5 Flags: Ports Bound: 0 Node...

root@vmserv:~# pvecm status Version: 6.2.0 Config Version: 3 Cluster Name: cluster Cluster Id: 13364 Cluster Member: Yes Cluster Generation: 16 Membership state: Cluster-Member Nodes: 1 Expected votes: 1 Total votes: 1 Node votes: 1 Quorum: 1 Active subsystems: 5 Flags: Ports Bound: 0 Node...

# /etc/init.d/cman stop Stopping cluster: Stopping dlm_controld... [FAILED] # /etc/init.d/cman start Starting cluster: Checking if cluster has been disabled at boot... [ OK ] Checking Network Manager... [ OK ] Global setup... [ OK ] Loading kernel modules... [ OK ]...

Thanks for reply. 1) Not all nodes because I failed to add even 1 node, so I stoped. on "vmserv1" I executed: "pvecm add vmserv", got usual output which stoped on "Wating for quorum...", then I got timeout message . After googling I tried cman and pve-cluster restart on both servers, it didn't...

Hi. Just tried to set up cluster on PVE 2.1 and I failed. Don't know what to do with that. Here is the situation: 1) 3 servers (vmserv (10.101.0.10), vmserv1 (10.101.0.11), vmserv2 (10.101.0.12) ). 2) "vmserv" has VMs, other servers - no. 3) I started setup according to wiki...

:-)

Just do not remove software raid support from any kernel, please. Debian installer has the possibility of software raid setup - this is enough!!! No need implement a new installer, better focus on real things like virtualization, HA, etc. Those guys who can't use simplest thing like debian...