I'm posting this as a guide to help anyone who created FreeNAS/TrueNAS VM on Proxmox Host and need to replace or upgrade a failed Disk.
On FreeNAS VM identify the disk that's bad or needs to be replaced
Record Disk Name and GUID to be used for getting the Serial Number of the disk
Dashboard -->...
You've helped me tremendously with this info.
I've also created a freenas VM within Proxmox (Since I started my home lab and haven't changed over to a dedicated TrueNAS server because it just works).
Recently I had to make a few drive changes (size increase and failed drive) and I've been...
While trying to make changes to the network config on any of the interfaces I was presented with an error related to bond1 or bond2
iface bond1 - ip address can't be set on interface if bridged in vmbr2 (500)
I decided to do the following which resolved the issue:
1. Delete vmbr2 and vmbr3.
2...
The Bond config on Primary host vs Secondary host is different because during the Secondary host bond creation when I enter IPv4/CIDR I get an error. When I try remove that config on the Primary host I get and error as well.
Note:
I tried accessing accessing the GUI from the same subnet, for the first time since setting everything up and I can't access it.
I've never had to access it from the same subnet because my sever is on another floor in my home.
However I can access the GUI for the Secondary server from the...
Yes I can ping all the other IP interfaces from the main host:
root@dtrinibs:/var/log# ping localhost
PING localhost.localdomain (127.0.0.1) 56(84) bytes of data.
64 bytes from localhost.localdomain (127.0.0.1): icmp_seq=1 ttl=64 time=0.033 ms
64 bytes from localhost.localdomain (127.0.0.1)...
Hi nktech1135,
1. I just checked the firewall on the Primary server and I found one entry (unknown to me but not surprised because I installed the Nagios agent on that server).
root@dtrinibs:~# pve-firewall status
Status: disabled/running
2. The secondary server's...
Hi,
I'm trying to set up a cluster with two servers that are on the same subnet with no luck. Firewall isn't enabled on any of the servers. I've checked my internal firewall and confirmed none of the traffic is being blocked by router. I need to remove the block to my Primary server that only...
I'm on 6.1-7 and I can see the Features nesting option under the Container.
Can you send a screenshot of the Options section for your container?
If you don't see it in 6.1-8 you might want to try updating the config using my previous method...
Yes I saw that option but like you mentioned no disk were available in the drop down. So I decided to do to it the way I used above, but didn't think to only wipe the disk and try again.
Hi,
This was really helpful. I added a Marvell 88SE9230 PCIe SATA 6Gb/s Controller to my server to extend my current storage. I have my main proxmox install on a 500GB SSD which after a few VMs, CTs and backups ran low on space. So I added that controller so I can have a dedicated storage...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.