Recent content by DenissManolijs

Hi, Yes, we are using snapshots. Thanks for your help.

Hi, We are experiencing issue with virtual HDD size. We've got Windows Server VM with 2 virtual disks configured. First is 700 GB and it is located on mounted RAID device. Second is 20 GB and it is located at LOCAL storage and used by Windows as SWAP partition. Yesterday we found that 20 GB...

Thanks. Everything was done using qm snapshot.

Hi Support! Can You please help find more detailed info about Live Snapshot creation via command line. We would like to automate Live Snapshot creation but we can't find any information about how it's done using command line. Thanks!

So we've restarted all 3 nodes yesterday and that resolved the problem. Thanks everyone for advice!

Can You please assist me, where I can find these logs? I'm new to ProxMox. Thanks.

Thanks for Your advice, but our subscription plan implies only support via Community Forum. Thanks one more time! Will wait till someone from ProxMox stuff will reply.

So here is the result: node1 -> node2 root@pmvi1:~# ssh -o "BatchMode yes" 192.168.1.172 ls apctest.output pve-cluster-backup.tar.gz ssh-backup.tar.gz node1 -> node3 root@pmvi1:~# ssh -o "BatchMode yes" 192.168.1.174 ls node2 -> node1 root@pmvi2:~# ssh -o "BatchMode yes" 192.168.1.170 ls...

Yes we cleared browser cache, even tried to connect to GUI using other browser from which we have never connected to GUI. But today we have little changes, node2 sees node3 but its status is RED (see file attached). Powered on machines on node3 are shown like powered off, but I can see...

Hi. We have 2 node cluster and now we've added third node. To add node3 to cluster we used command pvecm add node1-IP-address, so now in GUI node1 and node3 sees all 3 nodes, but node2 sees only node1. pvecm status on node1, node2 and node3 shows all three nodes but when we are using GUI node 2...