bbx1_'s latest activity
-
Bbbx1_ replied to the thread PVE Full Mesh reconfiguration - Ceph (got timeout 500).Thank you, I was starting the service after but that must have been the issue. Once I set it to start on boot as you provided, everything came up fine. I believe previously I was able to select the migration network by using the 40GbE network...
-
Bbbx1_ reacted to Bu66as's post in the thread PVE Full Mesh reconfiguration - Ceph (got timeout 500) with
Like.
Hi @bbx1_, Your output shows the core problem: the frr.service was inactive. The status output also shows the service is disabled (Loaded: ...; disabled; ...), which is why it did not start automatically after you rebooted the nodes. You... -
Bbbx1_ replied to the thread PVE Full Mesh reconfiguration - Ceph (got timeout 500).I will try that and report back. I did see the /32 but I assumed it was a config preference within the documentation. Edit: Didn't help by adjusting to /32. On my first PVE host, if I run the command as you mentioned, I get this...
-
Bbbx1_ replied to the thread PVE Full Mesh reconfiguration - Ceph (got timeout 500).Hello, I've attached the files to my original post. I've created a separate text file for each command. Please let me know if you would like me to change around the formatting or make it easier to read.
-
Bbbx1_ posted the thread PVE Full Mesh reconfiguration - Ceph (got timeout 500) in Proxmox VE: Installation and configuration.Hello everyone, I have a 3-node PVE cluster that I am using for testing and learning on. On this PVE cluster, I recently created a CEPH pool and had 4 VMs residing on it. My PVE cluster was connected to my Mellanox 40GbE switch but I wanted to...
-
-
BHello. I'm planning to install PVE on servers that have one SSD and six disks. The idea is to configure Ceph OSDs in each disk and dedicate the SSD to the DB/WAL. When doing this configuration from the GUI, it doesn't seem to allow you to put...
