Recent content by ATX

To be honnest dont know / dont have the knowledge. But, I dont have big VMs, and if it works on LAN and no one can explain/document me why it wont work on WAN (again: no replication of drive/vms will be done) ; then i'll go for the "this will work". I "only" need is a centralized management and...

@Dominic Yes two different datacenters. I was doing the assumption that low latency is only required for for corosync real-time synchronisation (aka replication) and that it was possible not to use it.

@tburger In orange below why I would like to setup the cluster.

@tburger Thanks for your reply. So far I have firewall rule to only allow trafic from/to the two public IP, not other IPs. I am quite sure this is not ok for prod env.However this is not the case and and I just learning.

Hi Please consider the following configuration: Server_1 - Public IP: X.X.X.X - Local IP: 192.168.150.1 (location A) Server_2 - Public IP: Y.Y.Y.Y - Local IP: 192.168.1.1 (location B) -> Server_1 and Server_2 are not connected through a local network -> The two IP have no dedicated domain...

No ipv6 is disabled at home & proxmox. Thats awkward.

The domain name is a OVH Domain, initially pointing to host A. I did a subdomain of that domain, pointint to host B where proxmox is. sub.domain.com:1111 -> points to my VM and works sub.domain.com:8006 -> points to proxmox and does not works

Yes it is. mydomain.ext:11009 works (this is mapped to a VM port) but mydomain.ext:8009 does not works (this is the proxmox admin page)

@r.jochum With HTTPS: no reply (timeout) With HTTP: curl: (52) Empty reply from server

Actually port 8006 with public IP allows me to reach the administration console but it does not work with the domain name. Https or not.

Hi So far we were using proxmox with our public IP. We now would like to use it (and it's VM) though a public domain name (i.e. mypublicdomain.com:8006). Question: Is that possible to make proxmox respond to mypublicdomain.com:8006 without changing it's internal host name (default value is for...

SOLVED For traceability: I had to remove duplicated values from '/var/lib/pve-cluster/config.db'. CONCLUSION CHANGING HOSTNAMES SEEMS REALLY DANGEROUS AND MANY OTHER POSTS HAVE THE SAME ISSUE

-- Subject: A start job for unit pve-cluster.service has begun execution -- Defined-By: systemd -- Support: https://www.debian.org/support -- -- A start job for unit pve-cluster.service has begun execution. -- -- The job identifier is 53830. Aug 30 11:01:41 proxmox6 pmxcfs[7363]: [database]...

Hello I followed that guide to change my hostname: https://documentation.online.net/en/dedicated-server/tutorials/administration/proxmox-first-step I rebooted the server and.. now everything is down. (Sorry for the screenshots I cannot cut paste for my terminal, I can not even SSH I do use a...

For reference: https://forum.proxmox.com/threads/outgoing-traffic-blocked-from-vm-with-output-policy-accept-only-rules.69131/ "IP Filter = NO" was also required for the solution to work.