Recent content by Area TIC

  1. A

    Multipath iSCSI /dev/mapper device is not created (Proxmox 6)

    Autoreply, in my case i have well configured: - multipath-tools installed, service active and running - /etc/multipath.conf well configured for HPE 3PAR - 4 HBA path detected by rescan-scsi-bus.sh - restarting multipath-tools.service - multipath -ll haven't result - multipath -v3 respond "sdb...
  2. A

    Multipath iSCSI /dev/mapper device is not created (Proxmox 6)

    Hi Diego, finally what was the key? I have a similar issue! Thanks for your reply
  3. A

    Infraestructure: 8 nodes with proxmox 6.0 and ha cluster config each node with FC HBA HPE 8Gb 2...

    Infraestructure: 8 nodes with proxmox 6.0 and ha cluster config each node with FC HBA HPE 8Gb 2 x HPE StorageWorks 8/24 16p SAN switch HPE 3PAR StorServ 7200 2-N 3.2.2 MU4 Config: proxmox nodes configures with multipath two vluns config: one for vm storage and other for vm backups not special...
    • Area TIC
    • Profile post comment
  4. A

    Howto Win10 Guest BP for Proxmox 5.X

    Some update for this howto for Proxmox 5.x? In the wiki the howto is outdated.
  5. A

    Proxmox HA Cluster 8 Nodes + HPE 3PAR deployed!

    Proxmox HA Cluster 8 Nodes + HPE 3PAR deployed!
  6. A

    Storage types, contents and vm formats

    Hi all!, i,m a little confusing about that, i try resume in one table all the info. it´s correct? it´s update? Thanks!
See more
Top Bottom