Recent content by anigwei

Hi, True: In pve-no-subscription you have pve-kernel-4.4.98-3-pve which is 4.4.98-102 (patched one). Regards,

I've exactly the same issue on an HP Proliant server! Warning :eek::eek:

Hi, Thank you!! Problem solved: I enabled multicast group with that IP, on the affected Vlan, on the switch. Sorry! Regards,

Hi! I have a cluster of two Proxmox, one of them I had to remove from the cluster. Then, I formatted it, readded to the cluster, and I have some problems (typical problems :) ) regarding visibility between them. No mind, I know that Proxmox clusters are very "delicate" :) My question is...

Tom, did you manage to solve it? I have the same problem with a SAS Controller... (https://forum.proxmox.com/threads/troubles-iscsi-and-max_sectors_kb.25750/#post-164684) Thanks!

Hi, Same problem here, instead of iSCSI i have a LSILogic SAS controller (SAS1064ET). Obviously disks are fine, RAID is OK... and latest Proxmox 4.2 with 4.4.40-1-pve. Any news from this? [1038862.772719] blk_update_request: I/O error, dev sda, sector 14050080 [1038862.778778] sd 4:1:0:0...

Hi, So I did this: And mount it on your fstab: Regards,

Hi, I still have Px 3.4 on my HP nodes... :( Regards,

Hi! Yes, there are plenty of advantadges :) But, at install time, is there any way of choose if you want "new LVM layout" or "old /var/lib/vz into EXT4 partition"? Thanks!

Hi Fabian, Thanks for your answer. I was thinking of I/O congestion too.... but I have other servers (some older) and I've never seen I/O problems while transferring VM into them. This is a brand new Intel S2600WT2R with a LSI Logic / Symbios Logic MegaRAID SAS 2208 [Thunderbolt] (Intel...

Hi tom, Yes, /var/lib/vz it is present but inside root partition. I usually set maxroot to 10Gb... so now /var/lib/vz is 10Gb shared with system :) I'd like that Proxmox during install let the user choose whether use local-lvm or leave an entire partition to /var/lib/vz as before :) Thanks!

Hi, Something strange is happening related to storage... A VM also gets that kind of panics! Related to jbd2/vda2-8 (Storage?).

Yes, that's it. PS: Reboot entire machine and then check with a "brctl show" that vmbr0 is bonded to eth2 Regards

Hi, After deploying a new server with latest version (4.2) I've noticed that /var/lib/vz does'nt exists anymore. Instead, it uses LVM as RAW storage for VMs.... (It created local-lvm datastore). This is new in 4.2? Is it better than qcow2 files into /var/lib/vz as used to be before as the...

Hi rickv55, You can rename every "eth0" to "eth2" and restart networking. Remember to change bridge_ports eth0 to eth2 too.