Recent content by abbynormal

Okay have an update to my issue as I figured out the solution... well a user /u/hairy_tick over on reddit figured it out after I posted to /r/proxmox. Given EFI on my dell r610, it does not have the requirement to mount /media/RESCUE/boot, given the boot directory is already populated when...

Hey @Cedrox Thanks for providing clarification on this as I myself ran into the same confusion against what specific mount points I should be using. However I've now ran into another issue trying to follow your appended suggestions to the procedure. Based on your above comment, the partition...

Can confirm that that I ran into this same issue today. Dell R610, installing via bootable ISO USB and connected to display via onboard VGA port. After hitting "install proxmox" in the GUI installer, video output become unsupported by monitor. Installing via 7.1 and upgrading was an applicable...

Thanks for the very polite "google search dummy", and I don't disagree with that sentiment. I guess I was just looking for a sanity check for any gotchas. I found this which appears to be simple and promising. Also glad you mentioned drives, as that brings up another factor that I meant to...

I'm in a pickle. I have Proxmox installed on a dell r610 with a single 500GB SSD as the boot drive, and I have a 1TB I'm planning to move it over to. The real kicker is the drive is plugged into the h700 raid controller, and the only way for this controller to use the single drive is to setup a...

SOLVED: Seems issue was indeed a direct result of the vswitch behavior. Above all references to vbridges were with the standard Linux bridges. As a test, I created two new bridges, each tied to one unused phyiscial NIC. Then I cabled both of these NICs together. Finally, I tied one vbridge to...

I have what essentially equates to a L2 FW deployment flow, and I'm seeing some issues with the client not receiving traffic when return L2 FW rewrites the MAC with it's VE MAC. The following is my current setup, where all players exist within Proxmox: I initially had everything on vmbr1, but...

Hmm that's a good thought once I appropriately get it functioning in a privileged container. However that's a step beyond where I sit now, given privileged containers still do not function when attempting tap mode against bridge interfaces. Either my deployment of bridge interfaces in Ubuntu...

I hope this isn't too far outside of the scope of discussion here but I'm pulling at strings trying to solve this. I have a Ubuntu 18.04 container that I've been trying to install an OpenVPN server to in tap mode (bridged), with no dice. After attempting to activate the service, I'm left...