MINISFORUM MS-01 i9 13th - shutdown issue

[stich86]

Dear all,

i've got my MINIS MS-01 (i9 version) two days ago and install on it PVE 8.1.4 with kernel 6.5.11-8.
My major issue is when i try to do "power off", the machine doesn't turn off but stay on (obivusly is not reachable).

The BIOS is very limited, so no configuration about ACPI.

Any other suggestions?

Thanks in advance!

 

[homelabenthusiast]

Dear all,

i've got my MINIS MS-01 (i9 version) two days ago and install on it PVE 8.1.4 with kernel 6.5.11-8.
My major issue is when i try to do "power off", the machine doesn't turn off but stay on (obivusly is not reachable).

The BIOS is very limited, so no configuration about ACPI.

Any other suggestions?

Thanks in advance!

Have you waited long enough? When i shutdown my ms-01 (i9 13900H) it takes time to fully shut it down because of the vm and all that. Out of interest, how much ram have you installed in yours?

 

[stich86]

I have updated microcode and latest kernel, now is working as expected

 

[mlbpc]

I have updated microcode and latest kernel, now is working as expected

I'm getting the same issue. Can I ask where you got the microcode update from? I'm suffering issues after shutdown where I can't get the MS-01 to power back up again until I disconnect CMOS and wait a few

 

[stich86]

I'm getting the same issue. Can I ask where you got the microcode update from? I'm suffering issues after shutdown where I can't get the MS-01 to power back up again until I disconnect CMOS and wait a few

i've sent the unit back because integrated 10GbE has EMI issues in particular env

Anyway you can update to latest microcode using this command:

bash -c "$(wget -qLO - https://github.com/tteck/Proxmox/raw/main/misc/microcode.sh)"

 

[mlbpc]

i've sent the unit back because integrated 10GbE has EMI issues in particular env

Anyway you can update to latest microcode using this command:

bash -c "$(wget -qLO - https://github.com/tteck/Proxmox/raw/main/misc/microcode.sh)"

Thank you! It's starting to dawn on me that lots of people are reporting issues with these machines.

 

[stich86]

Thank you! It's starting to dawn on me that lots of people are reporting issues with these machines.

It has lot of potential, but bad support and some hw desing flaw

may be next rev will be better