Elgato HD60 Pro PCIe Passthrough Issue

eBell

Active Member
Jun 11, 2017
13
0
41
I've been trying to passthrough an Elgato HD60 Pro to a Windows 10 Pro VM, but when the VM starts it will hang on POST or will continuously show the spinner and reboot after a while.
I attempted to boot the VM into safe mode, but got the same result.

There aren't any errors displayed in ProxMox, and nothing outside of the VM is affected.

Forcing the VM to stop or restart will post the following error on the host:
Code:
vfio-pci 0000:02:00:0: timed out waiting for pending transaction; performing level reset anyway

Running lspci after this will display the following:
Code:
02:00.0 0000: 12ab:0380 (rev ff) (prog-if ff)
       !!! Unknown header type 7f
       Kernel driver in use: vfio-pci

A similar issue has been reported in a thread for unRAID, but the posted solutions of adding 'disable_idle_d3=1' to the vfio entry for the capture card hasn't helped.

The other posted fix of patching the kernel with an update to support Yuan-Yuan capture devices, and enable 'quirk_no_pm_reset' and 'quirk_no_bus_reset', is several years old at this point and I don't know if it would even be supported on newer kernel versions.


I currently have two PCIe devices passed into the VM (excluding the capture card); a GTX 760, and a USB 3 PCIe card.
I've tried swapping the positions of the capture & USB cards without any luck and have tried removing the USB card from the MV config to see if there was some sort of interference.

I'm running a dual Xeon E5-2670 setup on an ASRock Rack ep2c602-4l/d16, the system has full IOMMU separation.
 
very suprised there are so few people doing this, i am also having the same issue. im running a dual 2011v3 super micro board with full IOMMU, i get the same issues on boot. did you ever fix this?
 
I have run into the same issue trying to pass through an Elgato HD60 Pro, using an ASUS Prime board and Intel 11700k in a configuration that should support this. I have no issues passing through an RTX 2070 super as well as USB/NIC cards in the same slot.
 

About

The Proxmox community has been around for many years and offers help and support for Proxmox VE, Proxmox Backup Server, and Proxmox Mail Gateway.
We think our community is one of the best thanks to people like you!

Get your subscription!

The Proxmox team works very hard to make sure you are running the best software and getting stable updates and security enhancements, as well as quick enterprise support. Tens of thousands of happy customers have a Proxmox subscription. Get yours easily in our online shop.

Buy now!