My providers have given me an IP address for each node and a default Gateway.
In addition they have given a pool of IP addresses and a default gateway for general WAN access.
Everything is via a L2 VLAN.. My VM's ignore the vnet vlan and if I add a VLAN tag to VM it fails to boot.
Anyway...
I don't need to route between different subnets.
I have 3 X servers in my proxmox cluster, each with 2 X 10G nics. They are bonded together to give me a single 20G pipe on each server. I have been given a bunch of IP addresses and a Gateway for use between the servers. These are made available...
All my access to the outside world is via a VLAN (Imposed by the host provider)
I setup an EVPN but cannot make it function over the VLAN. Is this a limitation of the existing SDN implimentation or am I doing something wrong?
I have a new Proxmox 3 Node Cluster and am trying to configure EVPN.
I have installed frr on all 3 nodes and am under the impression that the Controller and other Frr related configuration gets generated by the SDN web interface. However I am prevented from adding an EVPN zone because there is...
I have a fresh installation of proxmox 3.1
I am trying to set up SMEServer as a VM to act as a DHCP server and gateway server for the proxmox ve and as well as external pc's.
Below is a diagram of my setup. I cannot get dhcp to any external clients. I haven’t even tried to setup the sme-server...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.