Today final pieces of hardware came in to finish my new server setup:
supermicro 6026TT.
Install of (final) 1.4 went smooth.
Copied some templates and .iso images (debian-503-amd64-netinst.iso & debian-503-i386-netinst.iso) onto the local harddrive.
Creating a new guest also went fine.
When i started it, the familiar bootup screen of debian came up, i choose expert install and then screen/console goes to "blank" with a underscore cursor in the top left corner. I tried both 64 & 32 bit images: same restults
pveperf output:
I burned the 64 bit image to a cd-rw to check if it would install on real hardware and it functioned without a hitch. So the image is (imho) not a suspect.
Here is the config of the guest:
Anyone some hints/tips/clues ?
supermicro 6026TT.
Install of (final) 1.4 went smooth.
Copied some templates and .iso images (debian-503-amd64-netinst.iso & debian-503-i386-netinst.iso) onto the local harddrive.
Creating a new guest also went fine.
When i started it, the familiar bootup screen of debian came up, i choose expert install and then screen/console goes to "blank" with a underscore cursor in the top left corner. I tried both 64 & 32 bit images: same restults
Code:
pveversion -v
pve-manager: 1.4-9 (pve-manager/1.4/4390)
qemu-server: 1.1-6
pve-kernel: 2.6.24-16
pve-qemu-kvm: 0.11.0-2
pve-firmware: 1
vncterm: 0.9-2
vzctl: 3.0.23-1pve3
vzdump: 1.2-3
vzprocps: 2.0.11-1dso2
vzquota: 3.0.11-1
vhost1:/vz/images#
Code:
#
pveperf
CPU BOGOMIPS: 76608.34
REGEX/SECOND: 669422
HD SIZE: 73.33 GB (/dev/pve/root)
BUFFERED READS: 112.15 MB/sec
AVERAGE SEEK TIME: 10.82 ms
FSYNCS/SECOND: 1503.09
DNS EXT: 45.52 ms
DNS INT: 19.42 ms
Here is the config of the guest:
Code:
vhost1:/etc/qemu-server# cat 101.conf
name: lenny64
ide2: local:iso/debian-503-amd64-netinst.iso,media=cdrom
vlan0: virtio=9E:68:07:28:01:94
virtio0: local:101/vm-101-disk-1.raw
ostype: l26
memory: 1024
sockets: 1
boot: da
freeze: 0
cpuunits: 1000
acpi: 1
kvm: 1
Last edited: