Search results

Hello, I'm seeing 0.033x per second input discards on all my nodes in the cluster with a random jump to 0.1 per second. Its constant over the last 400 days of monitoring in check_mk and I see the same thing on the hypervisors. I've upp'd RX and TX to 4096 on all node. Unifi AGG switches...

Hello again... decided to BLOW AWAY all spinning disks from my cluster -> seemed to be working okay except for the summary page... its completely blank. it shows 0 OSDs it shows blank pgs it shows no data about cluster activity... Reboot the ENTIRE cluster (full shutdown) and its still...

Hello There, I've had a cluster running since 2016 and been upgrading storage. The SSD pool has been excellent since day one but my spinning disks are causing me some serious headaches. My largest drives are two 14TB WDC WD140EDFZ. These are almost ALWAYS at 250MS. They are on the same HBA as...

Hello, I have been fiddeling with a reverse proxy setup for my cluster. While I can 100% get this functional, spice/VNC are off the table. Port 3128 has been added to nginx and shows access in the access log. [04/Nov/2021:02:51:17 +0000] "CONNECT...

Hello, I followed the upgrade guide as I want to move my cluster to PVE7. Post upgrade I'm stuck with 15 objects on a single PG that REFUSE to repair. It's been in a "stuck" state now for hours. There are no slow IO issues. Ceph osd logs look clean. I followed the posted proxmox upgrade guide...

Hello Guys, Single Node ceph guy again. Recently suffered a two drive failure and lost some PGs so I rebuilt my pools and restored from external backups. The restores are taking FOREVER. Testing against my SSD pool which used to perform closer to 500MB/s it's maxing out at 60MB/s. Node hosts...

Hello all, I made a huge mistake when I installed my proxmox storage (ceph) node. I installed the OS on those terrible slow Dell dual SD card devices. The limited size (16gb) left the OS and swap pretty tiny. I have cloned that install into two 120GB SSDs. Performance is way better and IO delay...

Hello All, With any writes or reads running I seem to see high IO delays but low cpu usage. Currently with data copying to an SMB share on a vm on another node over 10Gbit I see 2.66% CPU usage and 46% IO delay. Is this normal? Two pools are setup. One HDD and on SSD. Both are setup correctly...

Hello, I've been testing ceph in my dev cluster for a bit now and I've finally added a few SSDs. I edited the CRUSH map to force the default replicated rule to use HDD. I created a new SSD rule for type SSD and created a new pool. If I write any data to the pool I instantly get a health...

Hello, I have a large raw disk I backup to a usb disk mounted. The backup failed as I hadn't cleaned up the old backup first which tends to happen a few times a month. The failure happens when the disk runs out of space. Typically once it fails the used temp space is cleaned up and the inodes...

Hello Everyone, I had this NIC working in the past. Was working fine until I upgraded to 5.2 from 5.1. After the kernel updated to 4.15.17-2-pve my system failed to boot. I had to comment out the r8168 module in order to get the system boot outside of emergency mode. I'd like this card...