Hello all,
I am currently configuring my firewall and I have an issue when I activate it I can't reach my host...
So, my case :
I have add two rules in "Datacenter" to open 22/tcp & 8006/tcp, the source is set at 0.0.0.0 and the destination is set up at 149.202.X.X.
Content of...
From my client in local I have full speed an from remote to.
The problem isn't network speed ;-)
My WS to VM :
[ ID] Interval Transfer Bitrate Retr Cwnd
[ 5] 0.00-1.00 sec 112 MBytes 937 Mbits/sec 0 147 KBytes
[ 5] 1.00-2.00 sec 112 MBytes...
I have already try to create a new VM with different settings for the same experience trough RDP.
IPERF HOST To VM :
root@probeprox:~# iperf3 -c 10.0.4.124 -t 30
Connecting to host 10.0.4.124, port 5201
[ 4] local 10.0.4.200 port 59774 connected to 10.0.4.124 port 5201
[ ID] Interval...
I have not tested with Iperf but I use 100% NIC 1GB when transferring the VM to the shared folders of my hypervisor. I can also use 100% of the internet connection from my VM. It's only the RDP itself that displays a horrible rendering ...
Do you still prefer a test via Iperf?
Tested with official MS RDP Client and via Remmina+freerdp plugin. Both gived the same result = poor performance and grapghical issue...
And again both tools works fine on Xen VM =(
For the resolution : 800x600 / 1280x720 / 1920x1080 / 2560x1440
Hello everyone,
My testing Config :
- AMD Ryzen 1600X
- Asus Prime AB 350 Plus
- 4 x 8Go Crucial 2400Mhz
- 4 x MX500 Crucial 250Go in Raidz1 (/root & VM-Images only)
- 2 x 4To in raidz1 (vzdump, backup & ISO storage)
- Dual NIC 1Gbps
No general performance problem on the side of the Proxmox...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.