Search results

I installed ifupdown2, which uninstalls ifupdown, everything works now. I think maybe the template needs updating. Oct 28 19:05:30 50m-hashcat-001 networking[47]: networking: Configuring network interfaces Oct 28 19:05:31 50m-hashcat-001 info[96]: eth0: enabling syslog for dhcp...

PVE Packages: proxmox-ve: 8.0.2 (running kernel: 6.2.16-15-pve) pve-manager: 8.0.4 (running version: 8.0.4/d258a813cfa6b390) pve-kernel-6.2: 8.0.5 proxmox-kernel-helper: 8.0.3 pve-kernel-5.15: 7.4-4 proxmox-kernel-6.2.16-18-pve: 6.2.16-18 proxmox-kernel-6.2: 6.2.16-18...

I am trying to setup a Debian 12.1 (Bookworm) LXC CT. The container starts but it takes about 5 mins to get to a login prompt. Once the login did appear I ran apt update / upgrade and rebooted to the same issue. Upon inspection, systemctl shows networking.service has timed out. The network is...

I did a tcpdump on the eno3 and eno4 physical NICs and I can see the packets leaving the host. I can also see the ICMP packets on 50m-pfsense-001 now but the gateway is not responding... So, it appears that my switches are configured correctly, now I need to do some PFsense work to complete...

Ok, I have removed the vlan2 OVSIntPort. My physical network layout is as such: Internet ---- 50m-pfsense-001 ---- 50m-switch-001 ---- 50m-switch-002 ---- 50m-virt-003 (Proxmox) 50m-pfSense-001 has a VLAN2 setup with a gateway address of 10.2.0.1, when the VLAN tag is not set on the LXC, I...

I have updated all Debian / Proxmox packages as of today. Running Proxmox 6.3-2 I've just started diving into the world of VLANs and have run into an issue that I can't seem to get around. Host network config: auto lo iface lo inet loopback auto eno3 iface eno3 inet manual auto eno4 iface...

I ran an update on my host today and it included an update from kernel 5.0 to 5.3. I was using the nvidia-driver package to allow the use of my NVIDIA cards in a BOINC container. I get this upon running: apt install nvidia-driver Setting up nvidia-kernel-dkms (418.74-1) ... Loading new...

Yet if I use the linux bond and bridge, it works fine: auto lo iface lo inet loopback iface eno1 inet manual iface eno2 inet manual iface eno3 inet manual iface eno4 inet manual iface enp0s29f0u2 inet manual auto bond0 iface bond0 inet manual slaves eno1 eno2 eno3 eno4...

I have a new Proxmox install, I'm trying to bond my 4 ethernet connections and put all the traffic (vm+management) through one bridge. After I setup the networking and reboot I can't access anything over the network. Here's what I ended up with in /etc/network/interfaces: auto lo iface lo...