Customer has been running older version (5.x) and looking to renew. They are asking if they upgrade to the latest (8.1) but are concerned about importing the existing setup.
Is there any problem migrating upward two version release levels ahead of renewal?
Thanks and regards,
Stefan
Hello everyone,
I have open ticket with Support on this, but I also wanted to get some feedback from the PGM Community.
We have a customer that is considering using Proxmox Mail Gateway's for their monthly invoice batching. This is mission critical email that needs to go out without fail in...
Hello,
We have a PX node where the a compressed backup for the primary VM no longer fits in the defined zfs-backups storage areas (around 150g). A backup job fails at the end when it runs out of space. I have tried different compressions and types without success. At this moment, I am...
We are proving a proposal to a client and would like to recommend the best option to have shared storage for their cluster(s).
I have been looking through the forum during the past couple of days and found several threads on this topic. Unfortunately, I have not determined that the most...
Can this new ISO be used to load the new system in-place over the top of an existing installation or is a backup and restore required? How will it impact the current OS partition and ZFS pool?
Hello,
I wanted to get some feedback on Hampton's published tutorial - http://ghost2-k4kfh.rhcloud.com/proxmox-with-zfs-raidz-ssd-caching/
We are looking a create very similar systems with a single 60gb SSD and 4 physical drives, and this procedure seems like a good fit. So I am curious as to...
I have some DELL 1U servers with 4 SAS drives recently discovered that the built-in RAID was just a firmware (not hardware) implementation. I subsequently decided to try configuring the 4 disks as as Proxmox ZFS RAID 10 array and proceed with installation.
This appeared to work fine, but I am...
Hello,
Trying to install on PVE 5.0 on a DELL Poweredge C1100, and it does not appear to be detecting the hardware raid array correctly. While it does see that 4 disks, they are detected individually - even though a valid RAID10 array is defined and operational.
Base on the RAID BIOS config...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.