I was passing through a drive to a VM (I know I shouldnt do it this way, it is just temporary) but when I ran qm set 100 -scsi2 /dev/disk/by-id/... I got an error:
file /etc/pve/storage.cfg line 8 (section 'local-lvm') - unable to parse value of 'content': invalid format - invalid content type...
So I've been running proxmox for a while now, but I just recently plugged in a monitor. It just say's the following message: "Reading all physical volumes. This may take a while...". This is an issue since I'm not able to access the CLI. How do I go about fixing this issue?
So I'm trying to enable IOMMU so I can pas trough a PCIe device. I've follow the guide from the documentation but in the GUI it still says: "No IOMMU detected, please activate it.See Documentation for further information.".
When verifying if IOMMU is enabled using dmesg | grep -e DMAR -e IOMMU...
So I'm trying to install proxmox but after I select "Install Proxmox VE" It start to load but then it loads in the wrong resolution, because of this I cant see the next/continue button. I tried multiple monitors and both VGA and HDMI output's. Any help would be appreciated.
Edit: I'm using...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.