Recent content by rflaherty

So I have an old server and a new server, both are running proxmox. I was attempting to migrate about 600GB of data. It didn't need to be migrated quickly, but it's taken nearly two weeks. I ran the command inside of screen. One of the servers rebooted due to power outage and it literally erased...

No I did not. I didn't even realize that was there. I will try that!

I am using a package called s3fs which allows you to mount s3 object storage on a linux machine as a disk. When trying to mount it, I get the error fuse: device not found, try 'modprobe fuse' first After referencing this thread, I was able to figure out that I need to run the following...

Very possible, I would have to wait until next weekend to try it since it takes about 15 hours to transfer. My only hesitation to point to that as the issue is that I did an identical migration from and to the same Proxmox servers, with the exact same settings and had no issues.

I have attempted a direct dd over ssh migration of a particular VM which is an an older Proxmox 5.4-5 server to a new server running 6.1-7 three different times now, and I end up having the same issue everytime. This is the command that I used to do the migration (worked fine for my other VMs)...

I just encountered the same issue today, written to the USB drive exactly how it was described in the manual, using DD. This was ProxMox 5.1. This is a very simple issue that needs to be fixed.... for some reason this is hard coded in as a cdrom in the syslinux config, and it only works when you...

I am sorry if I shouldn't be posting this here, but I have this exact same issue on ProxMox 4, except it is a KVM VM rather than an LXC container, running CentOS7.

Tom, Gotcha! Thanks.

Is it normal behavior for ZFS in ProxMox 4 to only allow 6 drives? My server has 8 drives but I am only allowed to add 6 of them to any sort of ProxMox RAID Configuration.

I will also note that the ZFS pool does not show up as an option even when creating LXC container from a template.

I am using the command "pct restore", what option to I have to append so that I can specify the storage location. Essentially, it creates the .raw disk image file on local storage, but fails to create the disk. I also cannot upload a backup to the local storage via the Web GUI, it gives the...

How exactly were you able to get the OpenVZ container to run on the Rpool? I created an rpool, but I cannot get the actual container to run on the rpool.

I just fired up a new ProxMox PVE 4.0 server with ZFS and followed the proxmox instructions on how to restore my OpenVZ containers to it. I scp'ed the file over to /var/lib/vz/dump and then attempted to restore it using the pct restore command, but I get an error: Allocating group tables: 0/64...