Recent content by Okoolarnik

I'm sorry, it is wrong only here, I couldn't copy from proxmox console so I retyped it here. On the server it's exactly as You wrote. Still no matter what I try, in most cases I can not even ping the gateway (phisical node's IP but with 254 at the end). I started to think if my node's...

Trace route gives the same message (connect: Network is unreachable)

I have just removed gateway definition and restarted. Now on VM when I ping anything else than IPs mentioned earlier and gateway's IP I get: connect: Network is unreachable

In Proxmox panel I have set "vmbr0" for "Bridge", "VirtIO" for model and I have entered OVH Virtual MAC Adress. Here's /etc/network/interfaces for VM: # The loopback network interface auto lo iface lo inet loopback # The primary network interface allow-hotplug eth0 iface eth inet static...

Hello, I have a Proxmox 4.4 Node with three LXCs configured for OVH Vrack, but not connected to any cluster yet, since it's only node. One IP block is attached to the server. LXCs run fine. I decided to try a VM. I downloaded couple of Debian minimal iso images and created a VM using debian 7...

I had to add two lines after vmbr2 definition #Bridge to Ovh Vrack auto vmbr2 iface vmbr2 inet static address 172.16.0.1 netmask 255.240.0.0 network 172.31.255.255 bridge_ports eth1 bridge_stp off bridge_fd 0 post-up /sbin/ip addr add 172.16.0.100/12 dev vmbr2...

Thank You very, very much, It worked. I had to modify a little bit /etc/network/interfaces, but Yours put me on a right track.

Hello. I have 2 serwers (SP-64) from OVH in their vRack, each with ProxMox 4.4 OVH's distribution installed. Adding linux container is not a problem, containers are connected to the "outside world", everything works just fine, except... I created new cluster on the first server, and I try to...