Recent content by MasterG87

Ok it was the USB Port. I did the passthrough and Bluetooth works properly. I was looking for a solution for such a long time. Thank you.

The output of hciconfig -a is: hci0: Type: Primary Bus: USB BD Address: C0:B6:F9:C6:04:39 ACL MTU: 1021:4 SCO MTU: 96:6 UP RUNNING RX bytes:781 acl:0 sco:0 events:57 errors:0 TX bytes:2735 acl:0 sco:0 commands:57 errors:0 Features: 0xbf 0xfe 0x0f 0xfe 0xdb 0xff 0x7b 0x87 Packet type...

I am still unable to figure that problem out. Does anybody has an idea where to look?

Here some further details. I activated IOMMU on the host: dmesg | grep IOMMU [ 0.000000] DMAR: IOMMU enabled [ 0.004000] DMAR-IR: IOAPIC id 1 under DRHD base 0xfed65000 IOMMU 1 and this is the output of: find /sys/kernel/iommu_groups/ -type l...

Ok I tried the settings you proposed and I wasn't able to succeed. I might have picked the wrong ID for the passthrough. When I do "lspci -nn" on the host, I get: 00:00.0 Host bridge [0600]: Intel Corporation Device [8086:31f0] (rev 03) 00:00.3 System peripheral [0880]: Intel Corporation...

Hi, I have installed Proxmox 5.3 on my Gigabyte Brixx GB-BLCE-4105. It also has an Intel Bluetooth Wifi Chip called Intel AC 3168 onboard. On the Proxmox host I am able to use the bluetooth device properly and I can find several bluetooth devices with bluetoothctl - scan on But If I do the...

Thanks for your hint. With your help I found the solution to the problem. I didn't knew that it was related to my processor, thats why I didnt find anything suitable. The solution to the problem is given here: https://forum.odroid.com/viewtopic.php?f=170&t=32943 see post of n2qcn » Sun Dec 09...

I think its impossible to activate Legacy Mode on my board, because its not available anymore. I read such an information for another board from asrock j5005 of the same age. Is it impossible to install Proxmox without Legacy Mode?

How can I change from UEFI to Legacy mode? In the Bios setting I have, I can't change the UEFI setting (see the picture). I am using Bios F5 currently and I have tried the preinstalled Bios F4 as well.

Hi, I tried to install Proxmox on my Gigabyte BLCE-4105 with Celeron J4105, 8GB RAM and 256 GB SSD by a bootable USB Stick with the 5.3.1 Iso file without success. I have put the Iso file on the stick by BalenaEtcher or ImageUsb or the command dd on my Mac/Windows. Always with the same...