https://www.centos.org/forums/viewtopic.php?t=54984
In case anyone needs to setup console on Centos7 VM:
1) Edit the /etc/default/grub file. Append the console=ttyS0 statement to the grub config file at the end of the GRUB_CMDLINE_LINUX line: console=tty0 console=ttyS0,115200
2) Create the...
My 0.02. If you have bond (say, LACP) on the top of interfaces, you can use the following syntax:
pre-up ip link set eth0 mtu 9000 && ip link set eth1 mtu 9000 && ip link set bond0 mtu 9000...
I did pretty much the same as @black4, except I didn't have "too many PGs" message.
My troubles started when I execute this:
ceph osd crush tunables optimal
After that only ~610 pgs became active, other ~5000 became activating+remapped. I changed tunables back to hammer:
ceph osd crush...
It appeared the particular osd is broken:
# devices
device 0 osd.0
...
device 5 osd.5
device 6 device6
device 7 osd.7
...
device 23 osd.23
when I deleted that OSD - everything is recovered.
but when I tried to add it back - the issue came back.
Any thoughts?
I saw similar posts around, but I...
I tried complete reboot (with VMs down) - this didn't help. The only thing which kind of worked was to add two small machines as temporary monitors to create quorum. However I need to resolve root cause asap :(
Hello,
After successful upgrade Proxmox 4.4 to Proxmox 5.1 we decided to go with BlueStore instead of FileStore. As soon as I deleted one FileStore OSD and created BlueStore instead, ceph became unresponsive. It appeared that 2 of 3 monitors crashed, and failed to start.
Here is the snippet of...
@Tarek Damak
If you have VMs deployed in local-lvm - then yes, you'll lose them. If you have your VMs deployed in local - then you're safe.
You can do the following:
- delete local-lvm storage in gui
- lvremove /dev/pve/data
- lvresize -l +100%FREE /dev/pve/root
Then you need to boot from...
If you have troubles with editing /etc/pve/firewall/cluster.fw, try to disable firewall manually on each cluster's node:
pve-firewall stop
Than
chmod u+w /etc/pve/firewall/cluster.fw
which allows you to edit the file.
After editing start firewall back:
pve-firewall start
Hello,
I'm using PM v4.4. Recently I switched from pam authentication to "Proxmox VE authentication server", and have very the same behavior of the console. Taking in account @udo 's comment above regarding pam users, if I create pam user it works fine. But how to propagate this to proxmox...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.