Ok So here is what happened, I wanted to install ceph octopus on all 3 nodes. This node accidentally got quincy setup started and I could not revert it back. So I went with quincy on all 3 nodes and it worked out.
There should be a way to revert if you accidentally start wrong ceph version...
I have 3 nodes all same hardware and specs. I was able to install ceph on 2 of my nodes successfully but it only fails on third one and I can't figure why. Any pointers please ?
root@hp2:~# pveceph install
update available package list
start installation
Reading package lists... Done
Building...
I think I ended up replacing the cards. Here are the ones that worked for me
lspci -k | sed -n '/Ethernet/,/Kernel/p'
01:00.0 Ethernet controller: Intel Corporation Ethernet Controller 10-Gigabit X540-AT2 (rev 03)
Subsystem: Dell Ethernet 10G 4P X540/I350 rNDC
Kernel driver in...
I have a 9 node cluster - all of them have same repositories and sources list but only on 1 of the node I am getting this error.
Starting system upgrade: apt-get dist-upgrade
Reading package lists... Done
Building dependency tree
Reading state information... Done
Calculating upgrade...
pvecm status
Cluster information
-------------------
Name: proxmox-cluster
Config Version: 23
Transport: knet
Secure auth: on
Quorum information
------------------
Date: Sun Feb 28 23:20:59 2021
Quorum provider: corosync_votequorum
Nodes: 10...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.