Recent content by genel

I, too, am having this problem on 7.2-3.

What has happened with this? I am running version 7.1-10 and the problem still exists. The patch recommended above does not work. I made both changes and still can only access 3 devices.

Other than it was Proxmox 6.2, I don't know the exact revision of the component software. I have an unused USB 3.1 Gen 1 (5000 mbs) available, would that work? Is there a beta program for qemu 7? How does on join?

Yes, it worked just fine before the upgrade. I liked it because there are four drives in the cabinet and I could assign them to different machines. Do you know when Proxmox might support the faster devices?

I just upgraded Proxmox from version 6.2 to 6.4 (now running 6.4-8). One of my virtual machines has problem starting. I get the following warning: kvm: Warning: speed mismatch trying to attach usb device "USB3.1 SATA Bridge" (unknown speed) to bus "xhci.0", port "1" (full+high+super speed) The...

Thanks, this helped me a lot. But to get it to work I had to do this also: a2enmod proxy_wstunnel It took me a few minutes to figure out why it still did not work after following you example. So I post this to help others.

No luck with that. I made the change and ran update-grub and it made no difference. Using the grub command link I ran videotest and it produced out of range errors on the monitor. I tried enabling GRUB_GFXMODE=640x480 but that did not help either.

I also have this problem. It is not causing any issues at the moment, because I can get into the system with SSH. But, its kind of scary to not have the console work. I successfully installed Proxmox version 2.2, booting from CD and setting everything up using the GUI screens. But when the...