Actually, I believe I just got this to work with using device-id rather than /dev/sdx
root@proxmox:~# zpool replace rpool /dev/disk/by-id/ata-ST31000333AS_5TE02E7P-part3 /dev/disk/by-id/ata-WDC_WD1003FBYX-01Y7B1_WD-WCAW34501541
Make sure to wait until resilver is done before rebooting...
I kept getting a /dev/sdf is in use and contains a unknown filesystem message and I could not figure out why.
Currently
pool: rpool
state: DEGRADED
status: One or more devices could not be used because the label is missing or
invalid. Sufficient replicas exist for the pool to...
During the PVR install if you have say a 480GB hard drive, only use 240GB of it and the rest will just be wasted so to speak. That would be a 50% over provisioned drive.
First off sorry for another SSD thread, I see a bunch of topics on this but some seem to contradict each other.
I obtained a new to me Dell R710, tossed in a H310 controller, cross flashed it and put it in IT mode with BIOS so I can boot from the drives. Now that I've been reading for hours...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.