Recent content by bevanswb

This is the config file that I had created. Does this look right? blacklist { wwid .* } blacklist_exceptions { wwid "3600c0ff00044aa526e41f15e01000000" } multipaths { multipath { wwid "3600c0ff00044aa526e41f15e01000000" alias mpath0 } } defaults { polling_interval 2...

As shown in the screenshots below: I have the san operating under two different ip ranges 192.168.1.* and 192.168.4.* as the node nics correspond under the same subnets. Additionally, In this test environment, I had kept them on the same subnet (192.168.1.*). It, however, does not matter if I...

An update: Yesterday I had taken a server that we had had different from our host device (test) and installed the same version of proxmox as on our host devices. I had removed the mappings from other host devices and installed proxmox. On the server mentioned here (test), it has two nic cards...

root@SABRETOOTH:~# lsblk NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT sda 8:0 0 931G 0 disk ├─sda1 8:1 0 1007K 0 part ├─sda2 8:2 0 512M 0 part /boot/efi └─sda3...

Attached are the requested outputs of commands listed.

Hi, I work at a local school district and I am trying to setup ISCSI based storage on our newer dell me series san. I have run into several issues while trying to set this up and was hoping that maybe someone could point me in the right direction. In our environment we have 3 hosts with proxmox...

Hi, I work at a local school district and I am trying to setup ISCSI based storage on our newer dell me series san. I have run into several issues while trying to set this up and was hoping that maybe someone could point me in the right direction. In our environment we have 3 hosts with proxmox...