Does anybody have this working on the Erying board where they have not also flashed to the Lightning BIOS? I have tried both of these similar guides that were not specific to this motherboard:
https://www.reddit.com/r/homelab/comments/b5xpua/the_ultimate_beginners_guide_to_gpu_passthrough/
https://www.reddit.com/r/Proxmox/comments/lcnn5w/proxmox_pcie_passthrough_in_2_minutes/
For me it dies at the point where you start VM with the 1050Ti GPU added as a PCI device to the VM - whether is set as the primary GPU or not. The host reboots and the log shows the following:
Googling for "D3hot to D0" proved unfruitful, but I'm wondering if turning off ACPI for the video card would help. I tried turning ACPI off altogether in /etc/default/grub, but then the machine boots with only one CPU core.
The following guide seems to have success after reflashing to Lightning BIOS, but I'd prefer not to do that if possible:
https://gitlab.com/baiyibai/erying-engineering-sample-hypervisor
https://www.reddit.com/r/homelab/comments/b5xpua/the_ultimate_beginners_guide_to_gpu_passthrough/
https://www.reddit.com/r/Proxmox/comments/lcnn5w/proxmox_pcie_passthrough_in_2_minutes/
For me it dies at the point where you start VM with the 1050Ti GPU added as a PCI device to the VM - whether is set as the primary GPU or not. The host reboots and the log shows the following:
Code:
May 22 13:56:27 erying-1 pvedaemon[2905]: start VM 105: UPID:erying-1:00000B59:000065C1:664D6CEB:qmstart:105:root@pam:
May 22 13:56:27 erying-1 kernel: vfio-pci 0000:01:00.0: Unable to change power state from D3hot to D0, device inaccessibleGoogling for "D3hot to D0" proved unfruitful, but I'm wondering if turning off ACPI for the video card would help. I tried turning ACPI off altogether in /etc/default/grub, but then the machine boots with only one CPU core.
The following guide seems to have success after reflashing to Lightning BIOS, but I'd prefer not to do that if possible:
https://gitlab.com/baiyibai/erying-engineering-sample-hypervisor