Hi,
I have here a cluster of 5 nodes (all running the same version 2.0 of proxmox). After one week, one of the cluster nodes was not accessibly by the ui. The vm's were already running. The kernelog says:
kernel: Neighbour table overflow.
kernel: __ratelimit: 62 callbacks suppressed
As mentioned in some forums, I increased the threshholds.
After this, I restarted cman. Anyway, the node is not accessable by the ui.
After this, I made a complete upgrade of the cluster to version 2.1 (without a restart of the cluster nodes). The result: No other node than the UI nodeis accessable by the gui. But the vms are running.
The cluster itself looks ok. pvecm status means
pvecm status
Version: 6.2.0
Config Version: 9
Cluster Name: pimi-cluster
Cluster Id: 45492
Cluster Member: Yes
Cluster Generation: 4236
Membership state: Cluster-Member
Nodes: 5
Expected votes: 5
Total votes: 5
Node votes: 1
Quorum: 3
Active subsystems: 5
Flags:
Ports Bound: 0
Node name: node03
Node ID: 3
Is there any way to get the gui running (without a restart of the cluster nodes and a shutdown of my vms)?
Regards
Daniel
I have here a cluster of 5 nodes (all running the same version 2.0 of proxmox). After one week, one of the cluster nodes was not accessibly by the ui. The vm's were already running. The kernelog says:
kernel: Neighbour table overflow.
kernel: __ratelimit: 62 callbacks suppressed
As mentioned in some forums, I increased the threshholds.
After this, I restarted cman. Anyway, the node is not accessable by the ui.
After this, I made a complete upgrade of the cluster to version 2.1 (without a restart of the cluster nodes). The result: No other node than the UI nodeis accessable by the gui. But the vms are running.
The cluster itself looks ok. pvecm status means
pvecm status
Version: 6.2.0
Config Version: 9
Cluster Name: pimi-cluster
Cluster Id: 45492
Cluster Member: Yes
Cluster Generation: 4236
Membership state: Cluster-Member
Nodes: 5
Expected votes: 5
Total votes: 5
Node votes: 1
Quorum: 3
Active subsystems: 5
Flags:
Ports Bound: 0
Node name: node03
Node ID: 3
Is there any way to get the gui running (without a restart of the cluster nodes and a shutdown of my vms)?
Regards
Daniel