mulitpath iscsi

Hi everyone! I would like to ask you for help: I have a Proxmox 8 installation with next networks: vmbr0 (10Gbps network) Management network/proxmox web-interface (192.168.10.0/24) vmbr40 (40Gbps network) trunk connection with vlan awareness enabled vlan9 (part of vmbr40 iface) (192.168.25.0/24)...

the proxmox servers have 4 interfaces each, I would like to bound 2 interfaces for the vis and use the 2 others for a multiparty configuration and connect to the ISCI targets via these 2 interfaces in a multiparty manner. Is there a way to do it other than putting the NAS on a different...

Hi, In my enviroment I have a SAN storage connected to my proxmox nodes with 2 different fabric and each node is connected on both fabric. Obviously I have configurated a multipath service on all node but if I reboot one of the fabric in order to test the failover all of my proxmox nodes and vms...

I have setup 3 hosts running and have setup LVM storage on top of iSCSI. When initially installed everything worked great and multipath was active. Under testing (pull a cable) a failed path was identified as faulty almost immediately and once plugged back in the path was active. The problem...