Hello Everyone!
I've been trying Proxmox recently on a server and I'm having a rather unusual problem with the web management interface.
I created a 'Linux Bridge' to have an internal switch (similar to what i'm used to in Hyper-V) and I want to assign a local ipv4 and ipv6 to that interface that will be routed through a complex internal vpn network that has dual-stack internal ips.
If i try to setup a 10.0.0.x ip address alone it will accept it just fine but whenever I try to setup a local ipv6 i get this error:
Parameter verification failed. (400)
address: fc:99::a:1:1 with type 'RESERVED', cannot be used as host IPv6 address
This makes no sense to me as it stops me from using a local ipv6 range but that's the entire point of it..
Is there any way to override this behaviour or is this a bug to be reported?
I've been trying Proxmox recently on a server and I'm having a rather unusual problem with the web management interface.
I created a 'Linux Bridge' to have an internal switch (similar to what i'm used to in Hyper-V) and I want to assign a local ipv4 and ipv6 to that interface that will be routed through a complex internal vpn network that has dual-stack internal ips.
If i try to setup a 10.0.0.x ip address alone it will accept it just fine but whenever I try to setup a local ipv6 i get this error:
Parameter verification failed. (400)
address: fc:99::a:1:1 with type 'RESERVED', cannot be used as host IPv6 address
This makes no sense to me as it stops me from using a local ipv6 range but that's the entire point of it..
Is there any way to override this behaviour or is this a bug to be reported?