I am using the qdevice method with the RPI.
Good to know this idea is sound. I think I'll start taking the steps to refactor my Trunas box to be a PVE+PBS solution. I'll need to verify some of the other workloads the Trunas server are portable before doing that. The other thing I could do is...
Has there been any thought of allowing the backup server to join a cluster as a node for quorum purposes only? I currently have a 2 node lab and am using an RPI as an arbiter but I also have a Truenas server for backups in the mix for that cluster. I have thought about replacing with a Proxmox...
This is a super old thread but in the 5.4 version of Proxmox I had a weird issue with LACP bonds giving me 50% packet loss. My cluster didn't come back in a stable way after a power outage. Generally I get it back with some pve-cluster restarts/massaging but this time it was a pain and I had...
The key here may be Sata controller or Raid1 setup. I have had similar issues after upgrading to Proxmox4 and here is how i solved it.
In my logs I had a bunch of messages like this and have had them since the 2.6 kernel with no poor iowait performance or high load:
ata5.03: failed command...
Yes that was the intention. However the hardware on the nettop is not stable and I have scrapped this project. I originally had intended to use an 8gb SSD that was lying around. Thanks for the advice Udo. If this gets picked up again, I'll spring for a larger SSD.
This was a useful tip. I have had a bunch of issues with a 2 node cluster that I was able to resolve with this tip.
Here is how I did it:
Separated the cluster by removing the cluster config. I had backed up /etc/pve before I started working on this. The last copy command puts back the...
Hi All,
I have a goal of installing proxmox on a very small nettop system for use as a quorum server (proxmox/ceph) for an existing 2 node test cluster. I am currently targeting deployment on a 8GB SSD. While it is known that the installer will choke on deploying to a drive this small, I am...
I have a similar issue. I have 2 node cluster that I cant put together. Was working fine until I upgraded to 3.0 a while a go. I get the same error messages you do and my setup in LACP bonds to a pair of Netgear GS716Tv2 which are also connected to each other via LACP. Multicast seems ok...
I have a question about this. I am looking at a PCI-E controller with the ASM1061 chip (Mediasonic HP1-SS3) for an external multi-bay e-sata box with port multiplier. Its not clear if the 2.6 kernel will support this controller in this use case (non bootable). Can you give some input on this...
I haven't completed the tests for the 802.3ad bond but I have had great success with this setup:
2x Netgear GS716T connected to each other with a 2 port LACP LAG
Proxmox server with 2x PCI-E network cards, RTL8111/8168B based Gigabit based
One PCI-E network card plugged into each swich
No...
Just an update to this. The issue is with the balance-alb bond type. I was trying to use this to split the bond over 2 switches for redundancy. I setup another test using 2x Netgear gs716t units and the only way balance-alb works is if the bridges that the VMs are using all are in the same...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.