Recent content by MajorD

Do you still have a problem now that you re-created the cluster? It will be practically impossible to troubleshoot something that no longer exists.

On each pve host, do a "cat /etc/hosts" and post each result.

Also, please post all three hosts files specifying on which host they are from.

I meant the system will not be degraded if it just has to fix bad reads/writes.

This is my understanding on ZFS: Remember that with ZFS, a read/write error (bad sector with possibly unrecoverable error) is not the same thing as losing an entire disk! ZFS will automatically fix bad read/write. The system will not run degraded. If you have a bad disk (then you have a lot...

Update: This may not be a Proxmox issue but I would appreciate any idea on how to troubleshoot. I have tried using two separate Android devices. Doing scenario 2 with device 1 allows the openVPN connection with that device only. Device 2 does not have access. I connected with device 1, then...

Did you do a "apt-get update" then a "apt-get dist-upgrade" before installing ceph?

Proxmox 5 Beta 1 up-to-date. All Proxmox firewalls off (Datacenter, host and container). TUN interface configured on openVPN container. Port forward from internet router UDP port 1194 to internal ip of openVPN container. Port forward from internet router UDP or TCP port 443 to internal ip of...

Have you tried apt-get dist-upgrade?

I have 3 network interfaces on a home system. One GB NIC on the motherboard and two in a dual port GB NIC. With Proxmox 3.2, the NIC names were as expexted: eth0, eth1 and eth2. In testing Proxmox 5 BETA, the interface names are now: enp4s0, enp3s0f0 and enp3s0f1. Is this expected/normal?

Please read the instructions. DO NOT do a apt-get upgrade! Just do: apt-get update && apt-get dist-upgrade -y

I suggested using GB because of the mention that it was difficult to do GiB on the graph. In fact, either one would be good as long as it is consistent.

Why not be consistent and show GB in all cases?

Up

What is the difference in Ceph cluster network and public network? Usually, they are both showing the same address in the config file. Anyone knows? Thanks.