Hi there,
fence_node using fence_ipmilan is not working, alway returns status failed.
This is the latest pve-version, there was something mentioned in the changelog, but nothing to specific
pveversion
pve-manager/3.3-1/a06c9f73 (running kernel: 2.6.32-32-pve)
fence_tool ls
fence domain...
Hi to all,
my cluster is setup at Hetzner, they do provide a fail-over subnet for the cluster.
What would be the best way:
- write a wrapper for fence_ipmilan, so that the fail-over subnet might start on the active node, if the "fenced" node had the FO-Subnet
- use the "service" section in...
Me neither. However I found a "solution", I moved the cluster IP to the beginning of the ovs bridge.
And i had to define "eth1" as static, like this:
allow-vmbr1 eth1
iface eth1 inet static
address 192.168.20.1
netmask 255.255.255.0
ovs_type OVSPort
ovs_bridge vmbr1
auto vmbr1...
Thanks for the help!
That is what i thought, it is not possible to declare an IP with an Interface, and then an ovs bridge with that interface. Instead, the IP has to become an IntPort as part of the ovs bridge.
I have followed your suggestions:
allow-vmbr1 inport1
iface inport1 inet static...
prxoxmox ve 3.2 drbd cluster plus openvswitch Here is what i have:
a fully working 2 NIC cluster, basically following the wiki : http://pve.proxmox.com/wiki/DRBD
What i like to have: to add open vswitch support.
Tried to add open vswitch via the GUI for private VM connectivity. Only one VM...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.