Hey @spirit ! (sidenote: I was just reading the SDN documentation, I'm really excited to try it out!)
The Cisco router is just routing, no ACLs in use for any of these networks.
I do have a Cisco ASA for one of my VLANs, and it's being phased out this quarter. Perhaps the ASA was changing the...
The fix is to manually put this in your host.fw (this is not available in GUI)
I set "nf_conntrack_allow_invalid" to a value of 1 (default is 0)
More info from docs
[OPTIONS]
nf_conntrack_allow_invalid: 1
enable: 1
After some more head scratching, it turns out I think this is a pve-firewall issue.
It's got me baffled. I use this same ruleset on 50+ PVE nodes, but it is not working on our PVE 7x cluster. I'm wondering if there is something different about pve-firewall that is breaking this.
The...
Hey All,
I have a cluster of 6 servers (pve-manager/7.1-12/b3c09de3 (running kernel: 5.13.19-6-pve))
All servers are the same hardware. I have this really bizarre issue that smells like MTU, but I have had no luck working on a solution. This is not your typical network problem.
I have about...
I reported a similar issue yesterday with an older system. It was recommended to try the 5.3 kernel from the pvetest repo.
The newer kernel fixed my issue.
So I am not a wiz with Chrome Dev tools - I didn't see any Javascript error happen when reproducing this.
I can say that I added more nodes to my cluster, so now the drop down for Migrate lets me pick other targets. If I toggle it over and over after about 30 seconds the migrate button finally...
Hey everyone,
I have an older IBM Blade that has been running VMware and I recently formatted it to run Proxmox.
The blade is now part of a cluster and is having some trouble running any existing VMs, or new VMs.
The issue is any VM on this host (blade03-ibc02) will "run" the VM but when...
Spoke too soon, It was working last week and now it's the same issue.
Hey @dcsapak, I will check for errors in the javascript console. I am unable to select another node (2 node cluster - no HA).
Thanks for reaching out Dominik, I've been lucky with this one - a simple reboot of blade06-ibc02 fixed this for me. My hunch is a previous apt dist-upgrade was performed and never rebooted.
Hi Everyone,
I have a simple 2 node PVE6 cluster (no HA) and am running into an issue I've never seen before. The issue is while using the GUI, I am unable to migrate (or live migrate) from the peer node "blade07-ibc02" to "blade06-ibc02". The thing is, it's only this direction, and only with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.